국내 최대 기계 및 로봇 연구정보

기술보고서

기술보고서 게시판 내용
타이틀	Deterministic Stress Modeling of Hot Gas Segregation in a Turbine
저자	Judy Busby, Doug Sondak, Brent Staubach, and Roger Davis
Keyword	Turbine; Computational fluid dynamics; CFD; Simulation
URL	http://gltrs.grc.nasa.gov/reports/1998/CR-1998-208666.pdf
보고서번호	NASA CR-1998-208666
발행년도	1998
출처	NASA Glenn Research Center
ABSTRACT	Simulation of unsteady viscous turbomachinery flowfields is presently impractical as a design tool due to the long run times required. Designers rely predominantly on steady-state simulations, but these simulations do not account for some of the important unsteady flow physics. Unsteady flow effects can be modeled as source terms in the steady flow equations. These source terms, referred to as Lumped Deterministic Stresses (LDS), can be used to drive steady flow solution procedures to reproduce the time-average of an unsteady flow solution. The goal of this work is to investigate the feasibility of using inviscid lumped deterministic stresses to model unsteady combustion hot streak migration effects on the turbine blade tip and outer air seal heat loads using a steady computational approach. The LDS model is obtained from an unsteady inviscid calculation. The LDS model is then used with a steady viscous computation to simulate the time-averaged viscous solution. Both two-dimensional and three-dimensional applications are examined. The inviscid LDS model produces good results for the two-dimensional case and requires less than 10% of the CPU time of the unsteady viscous run. For the three-dimensional case, the LDS model does a good job of reproducing the time-averaged viscous temperature migration and separation as well as heat load on the outer air seal at a CPU cost that is 25% of that of an unsteady viscous computation.